Dancer Skid Pads Bastl Boards Bolero

Dancer Skid Pads Bastl Boards Bolero

Dancer Skid Pads Bastl Boards Bolero – Die optisch ansprechendere Lösung dein Dancing Deck vor Verschleiß zu schützen. Die Pads werden individuell für jedes Deck designed, bieten eine hohe Passform, eine ergonomische Griffform und sind durch ihre dezente Form und das Farbmuster (welches durch Verschleiss sichtbarer wird) ein Optisches Highlight. Aufgrund der Passform können die Pads deutlich näher an der Aussenkante montiert werden, kombiniert mit der hohen Materialdichte bleibt ein natürliches „Pop-Gefühl“. Die Montage nahe an der Aussenkante kann ebenfalls das Chipping Risiko minimieren.

The pads are primarily held in place by clamping force, which also reduces the mechanical impact on the deck at the attachment points.

Material: Plastic, semi-flexible interface layer
Thickness: 8mm

Made by Lucky Engine

(sample photos, colours may vary)

Scope of delivery:
2 Dancer Pads made to fit
Stainless steel fastening material

Available for:
Luca Ballar
Bastl Waltz
Bastl Bolero
Crown Royal Tribe II
More episodes

The pads are designed on the basis of a 3D scan. As decks are finished by hand, deviations are possible. The best fit principle should be applied during assembly. Colour differences are caused by different material batches.

Assembly instructions for Dancer pads

Material required:
- Drill (5mm)
- Clamps or adhesive tape
- Pin (max. diameter 5mm)
- Allen key 3mm
- Optional: countersink, hammer

1. clean tails
2. align the pad with the tail
- It can be helpful to use wide painter's tape to draw parallel lines to the axis/axes.
Tape the mounting holes to use them as a reference point
3. fix the pads (screw clamps, staples, temporary bonding with adhesive tape)
4. transfer the mounting holes with a pin, alternatively with a centre punch or drill and a light drill bit.
Transfer hammer blow
5. remove pad, drill holes
- Apply little pressure, especially at the end of the hole, to prevent splintering/tearing.
prevent
- Optional: Lower top side
6. pad mounting