Dancer Skid Pads Luca Ballar

Dancer Skid Pads Luca Ballar

Dancer Skid Pads Luca Ballar - The visually appealing solution to protect your dancing deck from wear and tear. The pads are individually designed for each deck, offer a great fit, an ergonomic grip shape and are a visual highlight thanks to their subtle shape and colour pattern (which becomes more visible with wear). Due to the fit, the pads can be mounted much closer to the outer edge, combined with the high material density, a natural „pop feeling“ remains. Fitting close to the outer edge can also minimise the risk of chipping.

The pads are primarily held in place by clamping force, which also reduces the mechanical impact on the deck at the attachment points.

Material: Plastic, semi-flexible interface layer
Thickness: 8mm

Made by Lucky Engine

(sample photos, colours may vary)

Scope of delivery:
2 Dancer Pads made to fit
Stainless steel fastening material

Available for:
Luca Ballar
Bastl Waltz
Bastl Bolero
Crown Royal Tribe II
More episodes

The pads are designed on the basis of a 3D scan. As decks are finished by hand, deviations are possible. The best fit principle should be applied during assembly. Colour differences are caused by different material batches.

Assembly instructions for Dancer pads

Material required:
- Drill (5mm)
- Clamps or adhesive tape
- Pin (max. diameter 5mm)
- Allen key 3mm
- Optional: countersink, hammer

1. clean tails
2. align the pad with the tail
- It can be helpful to use wide painter's tape to draw parallel lines to the axis/axes.
Tape the mounting holes to use them as a reference point
3. fix the pads (screw clamps, staples, temporary bonding with adhesive tape)
4. transfer the mounting holes with a pin, alternatively with a centre punch or drill and a light drill bit.
Transfer hammer blow
5. remove pad, drill holes
- Apply little pressure, especially at the end of the hole, to prevent splintering/tearing.
prevent
- Optional: Lower top side
6. pad mounting